Touchscreen wireless receiver (10016) and Equipment-side transceiver (10017) together allows the touchscreen to be relocated inside the house without needing a cable to be run. The equipment-side transceiver is installed near the pool equipment and a RF signal is used to communicate with the touchscreen wireless receiver. This can be mounted somewhere near where the touchscreen is to be mounted in a position that will receive sufficient signal.
Internet Gateway (10030) is required to control the Connect 10 by the internet or by the mobile apps.
Connect 10 temperature and solar sensor kit (520146) allows the Connect 10 to measure the pool temperature and control pool heaters.
Where solar heating is used, you can add a Connect 10 Solar modulator lead (15211 - 3m, 15212 - 20m and 15213 - 50m) to be installed on the roof as roof (or hot) temperature sensors. Requires Connect 10 Temperature and solar sensor kit (520146).
Note: Requires installation by a licenced electrician. Required to be hard-wired to a circuit rated to a minimum of 32 amps, ideally 40 amps. Maximum load is 40 amps.
